Beurer MG 330 Mode D'emploi page 17

6. USAGE
6.1 Positioning the Shiatsu seat cover
1. Position the Shiatsu seat cover upright on a suitable seat with a seating surface and back rest (chair,
sofa or similar). Make sure that the entire surface of the seating surface
contact with the seat.
2. Ensure that the mains cable does not pose a trip hazard. Insert the mains plug
6.2 Adjusting the neck section
Start by adjusting the neck section
can be adjusted. Always make sure that the 4D massage heads
your neck comfortably and are not directed at your head.
1. Adjusting the height: (The corresponding drawing
the centre of the neck section
of the back section. This releases the locking mechanism and you can then move the neck section
to the desired height. Then release the PRESS button
neck section is now fixed in place and you can remove your hands from the device.
1
2. Adjusting the tilt: (The corresponding drawing
on the neck section
the adjustment, move the neck section
now in line with the back section
the optimum position for you. The neck section
section down once to a 90 degree position. The neck section
1
just, lift the neck section
6.3 Starting use
 CAUTION
Do not force or jam any part of your body, in particular your fingers, between the rotating massage heads
, or their holders in the device.
2 4
At first, just press your back carefully against the Shiatsu seat cover. Then check carefully
whether the massage position is pleasant for you and then shift your weight gradually towards
the Shiatsu seat cover.
The massage should feel pleasant and relaxing at all times. If the massage is painful or uncom-
fortable, stop the massage or change your position or the contact pressure.
1. Selecting the seat position: Sit comfortably and upright on the Shiatsu seat cover. Take care to ensure
you are positioned in the middle of the massager and that the massage heads
and right of your spine.
2. Switching on the device: Switch on the Shiatsu seat cover with the ON/OFF button
heads in the back section
4
3. Selecting the massage area for the back: Use the UPPER BACK button (upper back)
BACK button (lower back)
switch indicate the set massage area. The rotating massage heads
8
the starting position in the lowest area of the back and then move up and down in the set massage area
(upper or lower back).
4. "SPOT" massage: Press the SPOT button
arrow buttons
15
of the Shiatsu seat cover as required. Both the height and the angle
1
. With the other hand, press the PRESS button
1
and the other on the back section
1
. Now you can tilt the neck section
5
up until it engages.
1
switch on automatically.
5
to select the area you want to have massaged. The LED lights on the hand
13
to freely adjust the massage area up and down.
is shown on page 5.) Reach with one hand under
A
and allow the neck section
3
is shown on page 5.) To adjust the tilt, hold one hand
B
to stabilise the seat cover. At the start of
4
backwards until you hear it engage. The neck section
1
is now fixed backwards. To release it, move the neck
1
to start usage in a specific spot in the back area. Use the
14
17
and the back area
6
into a suitable socket.
9
are positioned so that they massage
2
at the top of the rear
3
forwards until it has reached
1
can now be moved freely. To read-
1
can move to the left
4
travel slowly upwards from
4
are in
5
1
to engage. The
1
is
1
. The massage
18
or the LOWER
12