The lamp
illuminates in
white and red
during operation
of the device.
Water is leaking
from the device.
Smoke is coming
out of the device.
Cleaning
1.
Remove the lid, fill the container with water and mild detergent,
then tighten the lid and turn on the device for about ten seconds.
2.
To thoroughly clean the device, remove the seal located in the
lid, wash and wipe it carefully to remove any residue of liquids
and food. Specially designed grooves facilitate the removal of
the seal.
3.
The body of the device can be cleaned with a damp cloth after
removing the glass container.
Note! Wash the various parts of the device immediately after use.
Note! Take special care when cleaning sharp parts.
Photos are for reference only, the actual appearance of the products may
The device is
blocked.
The silicone ring
is not properly
installed.
The device is
used for too
long.
differ from that shown in the photos.
Remove the food
blocking the device,
and then restart the
device.
Install the silicone ring
in the correct place
(fig. 9).
Stop using the device for
about 30-60 minutes, and
then restart the device.
EN