Costway NP11860 Mode D'emploi page 8

11
Slide Cover (Q) onto Lower Pole (B) from the bottom of this part.
Insert Foot (P) into the bottom openings of Lower Pole (B) and
secure these parts together using two M6x15 Bolts①. Slide Cover
(Q) over Foot (P) when assembly is completed. Follow these steps
to connect remaining part B's with remaining part Q and P. Please
take note of the bolt-threading inserts found near the top and bottom
of each Lower Pole (B). It is important to be aware of the placement
of these inserts to avoid error during construction.
12
To prevent parts from being damaged during this part of assembly, it
is recommended having one person at each corner of the
assembled frame who is able to lift the Upper Poles (A) to chest
height. Set the previously assembled Lower Poles (B) upright by
where each person expects to be able to place the bottom ends of
the Upper Poles (A) into their top openings. Each person should lift
the assembled top portion of the frame at the same time and insert
the bottoms of the A's into the tops of the B's. Insert two M6x25
Bolts② through the eyelets of Lower Pole (B), and into the
bolt-threading inserts found on the bottom of Upper Pole (A). Follow
this step to secure the opposite side of B to A. Follow these steps to
secure the all part A to part B. The screw holes on bottom of Part A
and on upper of Part B must be on the same side.
14
13
Lift Covers (Q) up, and screw four Stakes (T) through designated
eyelets of Feet (P) into the ground for extra stability. Repeat these
steps to secure the all part T to P.
12
CAUTION: THIS PRODUCT CAN NOT WITHSTAND HIGH WINDS
OR HEAVY RAIN. TO AVOID INJURY OR DAMAGE, WE
RECOMMEND THAT WHEN HIGH WINDS OR HEAVY RAIN IS
FORECAST THE ROOF, SIDE CURTAINS AND NETTING BE
REMOVED UNTIL THE STORM HAS ENDED.
WARNING
● Do not let any sharp objects touch or rub the surface of the product.
● When assembling, do not let children play around the working area.
● Please confirm all parts are correct before starting the assembly
process.
● Do not tighten all bolts and screws completely until the entire unit
has been assembled and set up.
● DO NOT USE POWER TOOLS.
● Power tools can overtighten screws and strip the threads.
● For each screw, tighten until you meet resistance and then tighten
one additional full rotation. DO NOT OVERTIGHTEN.
13
15