Publicité
Les langues disponibles
Les langues disponibles
•
Do the same for the other side.
STEP 2: WHEELS
•
Slide the wheel axle on the back of the motor base. Insert the pin and the locking cable.
STEP 3: LOWER AND UPPER HANDLEBARS
•
Turn the base of the engine so that it stands on the wheels and the tiller blades. Fasten the handle frame with
the screws and three wing nuts. Make sure the concave head is on the inside and the three wing nuts are on
the outside.
•
Attach the top handles in the same way as in the picture.
•
Tie the throttle cable with the supplied cable clamps. Make sure it is not too tight. If it is too tight, this can cause
the throttle cable to become caught and will affect engine performance. If this occurs, please cut the clamp
attached to the cable and replace it with a new one.
49
EN
Publicité
