Preparing The Remote Control; Using The Remote Control; Attaching The Stand - Bennett & Ross AV-5 Manuel Utilisateur

Preparing the Remote Control

First push to inside as the direction indicated by the arrow (See 1) and then Remove the battery
holder as the direction indicated by the arrow (See 2).
Replace the battery Set a new battery property with (+)side up as illustrated (See 3). Insert the
battery holder. Push in the holder to the original position (See 4).

Using the Remote Control

Face the remote control towards the player front face IR mark (remote control signal receiver).
Operation angle: About 30 degree in each the direction of the front of the IR mark. Note: The
lithium cell in the battery compartment of remote control has been secured for transport with a foil.
Before initial use please remove this foil so that the remote control is ready for operation.

Attaching the Stand

Turn the unit over as shown below, and align the mounting blocks on the top of the stand, with the
mounting openings located on the bottom of the main unit. Once in place, the 4 mounting tabs on
the stand will align with the 4 rectangular mounting slots located on the bottom of the unit. Make
sure the mounting tabs are lined up with the slots, and slide the stand towards the front of the unit
until the mounting stand it is fully inserted, and locked in place. Make sure the base is locked firmly
in place, so it does not come off.
To remove the stand, use both hands to hold the stand, and using two fingers, lift the two locking
tabs marked with arrows to unlock the base. Slide the stand towards the back of the unit to unlock.
When the stand is in unlock position, pull the stand upward to remove it.
14