Würth STP 150 POWER-S Traduction Des Instructions De Service D'origine page 16

OBJ_BUCH-1626-001.book Page 16 Thursday, March 1, 2012 2:12 PM
Action
Adjusting the Cutting Angle
Mounting the sliding shoe
Mounting the splinter guard
Orbital Action Settings
Adjusting the stroke rate
preselection
Switching On and Off
Guide the power tool toward
the workpiece only when
switched on
Lubrication when cutting metal
Plunge Cutting
Maintenance and Cleaning
❏ For safe and proper working, always keep
the machine and ventilation slots clean.
When replacing the power tool's cable is required,
have this carried out by a Würth master-Service or by
an authorised customer services agent for Würth
power tools, in order to avoid hazardous situations.
Figure Please observe
5
6
7
8
9
10
11
12
13
Clean the saw blade holder regularly. For this,
remove the saw blade from the machine and lightly
tap out the machine on a level surface.
Regularly spray penetrating oil onto the saw blade
holder (see figure 15, page 192).
Check the guide roller regularly. If worn, it must be
replaced through an authorised Würth after-sales
service agent.
Page
186–187
188
188
189
189
190
191
191
191–192
16