Power Dynamics NCBT Serie Manuel D'instructions page 3

INSTALLATION
1. Drill a hole in the ceiling, big enough to fit the speaker
(check technical specification sheet for size).
2. Connect the active speaker with the 12VDC adapter.
3. Connect active and passive speaker with speaker cable
(+/-) if applicable.
4. Insert the speaker in the hole.
5. Tighten each of the adjusting screws firmly (the locking
tabs will swivel into the rear surface).
6. Place the metal grill.
CONNECTING WITH BT
Before starting the BT connection be sure that the BT-function on active speaker is switched ON.
Connecting your BT-device to the speaker, follow below steps:
1. Turn on BT-function on your device (mobile phone, tablet etc.)
2. Search for "BT"
3. Connect with "BT"
Your device is now connected, no password needed.
DISCONNECTING OR RECONNECTING
If you want to change from BT-device, follow below steps:
1. Disconnect the current BT-device ("OFF")
2. Connect new BT-device by following above steps
If you move out of range or turn off the BT function on your BT-device, the BT of the speaker will disconnect. To
reconnect turn on the BT on the desired device, it will reconnect.
3