LEXIBOOK T1000 Serie Mode D'emploi page 21

1. Fix the device holder in the two holes on top of the Bluetooth
2. Place your device over the slot.
3. Connect one end of a cable (not included) to your device and the USB end to
the USB DC 5V
Notes: the personal device automatically charges when it is connected to the
Bluetooth
The Bluetooth
Bluetooth SIG, Inc. and any use of such marks by Lexibook® is under license.
Other trademarks and trade names are those of their respective owners.
© 2014 Bluetooth SIG, Inc.
Initial Pairing
1. Switch on the Bluetooth
Bluetooth
2. Activate the Bluetooth
instruction manual of your device on how to active this function.
3. Select the Bluetooth
the tower.
4. Once both device and tower are connected, play an audio or a video file.
Adjust the sound volume level using the keys on your personal device or the
volume buttons of the tower or remote control.
Re-pairing
When the tower or Bluetooth
1. Switch on the Bluetooth
Bluetooth
2. The Bluetooth
device it was paired with.
3. If no device is found, the Bluetooth
to select other modes: FM, AUX or L IN.
BT1000seriesIM1274_18Jun_V25.indd 21
All manuals and user guides at all-guides.com
CHARGING A PERSONAL DEVICE USING THE BUILT-IN USB PORT
charging port at the rear of the tower.
®
tower. Make sure the tower is supplied with power.
BLUETOOTH
®
word mark and logos are registered trademarks owned by
®
tower and press the SOURCE button to select
®
mode (bt). The Bluetooth
®
function on your personal device. Please refer to the
®
tower name and start pairing your personal device with
®
®
tower and press the SOURCE button to select
®
mode (bt).
®
LED blinks for 3 seconds and automatically finds the last
®
SET UP
®
LED blinks while searching for a device.
mode has been switched off:
®
LED continues to blink. Press SOURCE
21
®
tower.
19/06/2014 2:55 PM