Publicité
Les langues disponibles
Les langues disponibles
Injector
adjustment
Injector output is controlled by position of
indicator cap (2) that limits travel of
indicator piston (3) (→ fig. IPB 1).
To achieve advertised minimum output
setting, 0.001 in
3
(0.016 cm
3
), hand tighten
indicator cap (2) against it's stop, then loosen
approximately
/
turn.
1
2
Retracting indicator cap (2) two full turns
from hand tight position permits
maximum output of 0.003 in
3
to be dispensed.
Use graduations on indicator cap (2) as aid
in setting indicator.
When injector has been adjusted for
proper lubricant output, lock nut (1) is
tightened against face of indicator cap (2).
Item
Description
1
Lock nut
2
Indicator cap
3
Indicator piston
1)
Indicator cap must not extend beyond retracted position of indicator stem.
NOTE
Any output setting less than
should be monitored to verify actual
output volume.
(0.049 cm
3
)
1
2
/
turn
Indicator cap must not extend beyond
1
2
retracted postion of indicator stem.
personal injury or damage to
equipment.
Fig. IPB 1
3
8
CAUTION
Failure to comply may result in light
Publicité
