Sharp SJ-LD125E0XS-EU Guide D'utilisation page 11

• Do not press any button within the
following 3 seconds to keep chosen set.
• Super cooling will blink.
• If you keep on pressing, it will restart from
last value.
Note:Some built-in appliances may have a
stand-by mode.
3.2.5 Stand-By Mode
How To Activate ?
Set "2" set value and push set button until
all leds are blink three times.
How It Works?
In stand-by mode; all components will be
disabled. If user push set button while in
stand-by mode, all leds will blink three
times to show stand-by mode is active.
How To Deactivate ?
Push and hold set button until display
returns to normal working.After the mode
is deactivated, the "Alarm LED" may light
on the display because the product may be
hot. The "Alarm LED" will turn off when the
product reaches normal temperature.
3.2.6 Door Open Alarm Function
If fridge door is opened more than 2
minutes, appliance sounds 'beep beep'.
3.3 Temperature Settings Warnings
• Your appliance is designed to operate in
the ambient temperature ranges stated
in the standards, according to the climate
class stated in the information label. It
is not recommended that your fridge is
operated in the environments which are
outside of the stated temperature ranges.
This will reduce the cooling efficiency of
the appliance.
• Temperature adjustments should be
made according to the frequency of
door openings, the quantity of food kept
inside the appliance and the ambient
temperature in the location of your
appliance.
• When the appliance is first switched on,
allow it to run for 24 hours in order to
reach operating temperature. During this
time, do not open the door and do not
keep a large quantity of food inside.
• A 5 minute delay function is applied
to prevent damage to the compressor
of your appliance when connecting
or disconnecting to mains, or when
an energy breakdown occurs. Your
appliance will begin to operate normally
after 5 minutes.
Climate class and meaning:
T (tropical): This refrigerating appliance
is intended to be used at ambient
temperatures ranging from 16 °C to 43 °C.
ST (subtropical): This refrigerating
appliance is intended to be used at ambient
temperatures ranging from 16 °C to 38 °C.
N (temperate): This refrigerating appliance
is intended to be used at ambient
temperatures ranging from 16 °C to 32 °C.
SN (extended temperate): This
refrigerating appliance is intended to be
used at ambient temperatures ranging from
10 °C to 32 °C.
3.4 Temperature indicator
In order to help you better set your
refrigerator, we have equipped it
with a temperature indicator
located in the coldest area.
To better store the food in your
refrigerator, especially in the
coldest area, make sure the
message "OK" appears on the
temperature indicator. If « OK » does not
appear, this means temperature has not
been set properly
It may be difficult to see the indicator,
make sure it is properly lit.Each time the
temperature setting device is changed,
wait for the stabilisation of the temperature
inside the appliance before proceeding,
if necessary, with a new temperature
setting. Please change the position of the
temperature setting device progressively
and wait at least 12 hours before starting a
new check and potential change.
NOTE: Following repeated openings
(or prolonged opening) of the door or
EN - 10
OK