Publicité
Les langues disponibles
Les langues disponibles
3.7 Viewing ambient temperature
1)
Under on status, receiver light board or wired controller is
defaulted to display setting temperature. Press "TEMP" button
to view indoor ambient temperature.
2)
When "
is setting temperature.
3)
When "
indoor ambient temperature.
NOTE:
Setting temperature is always displayed in remote controller.
3.8 Setting X-FAN function
1)
In cool or dry mode, holding "FAN" button for 2 seconds to set
X-FAN function.
2)
When "
3)
When "
4)
When X-FAN function is on, the water on the evaporator will be
blown away until turning off the unit to avoid mildew.
3.9 Setting health function
1)
Under on status, press "
2)
When "
3)
When "
4)
Health function is available when the unit is equipped with anion
generator. When health function is on, the anion generator will
start operation, adsorbing the dusts and killing the bacteria in
the room.
" is not displayed, it means the displayed temperature
" is displayed, it means the displayed temperature is
" is displayed, X-FAN function is on.
" is not displayed, X-FAN function is off.
" is displayed, health function is on.
" is not displayed, health function is off.
Remote Controller YAP1F7
" button to set health function.
6
Publicité
