Bonnet Neve SKYVIEW PLUS Instructions Pour L'utilisateur page 28

NECTION UNDER OVERVOLTAGE CATEGORY III CONDITIONS (see fig. 17). The position of the
cut-out switch must enable its actuation in any emergency situation (maximum distance 3 m).
Show the position of the cut-out switch to any prospective operator.
The refrigerator must be installed by professionally qualified personnel, in accordance with the
instructions provided by the manufacturer and local regulations. Incorrect installation may cause
harm to persons, animals and property. The manufacturer assumes no responsibility for such
damage.
A supply cable of type HO5VV-F 1mm² or higher must be used for the main supply.
Make sure that the system power supply voltage corresponds to the values appearing on the rating
plate of the equipment. Consider also that the maximum allowable power voltage variation is +/-
6%.
IMPORTANT: THE EQUIPMENT MUST BE PROPERLY EARTHED. The manufacturer assumes
no responsibility for any damage resulting from non-observance of this safety principle. If
the cabinet must be installed far from electric power source, make certain that the con-
nection complies with the standards in force.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
THE MANUFACTURER DISCLAIMS ALL RESPONSIBILITY FOR ANY PERSONAL INJURY OR PRO-
PERTY DAMAGE ARISING FROM INCORRECT INSTALLATION.
6. TECHNICAL SPECIFICATIONS
The built-in electrical installation is composed of control devices lodged in the lower part of the
refrigerated cabinet. The technical details, which are also reported on the rating plate, inside the
display case (see fig. 8 on page 13) are shown in table III, page 13.
A-weighted sound pressure level is less than 70 dB (A). This refrigerated cabinet genera-
tes no harmful vibrations.
WE HEREBY DECLARE THAT THE DISPLAY CASE AT ISSUE COMPLIES AS EXECUTING EEC DIREC-
TIVE 1935/2004 ON MATERIALS AND OBJECTS FIT FOR CONTACT WITH EDIBLES.
7. LOADING PRODUCTS
Once the technicians have completed cabinet installation, switch it on through the wall cut-out
switch. The cabinet will then start its cooling cycle. Allow about two hours before loading products,
which must already be at their preservation temperature. THE DISPLAY CASE IS FACTORY-REGU-
LATED FOR THE ANTICIPATED PERFORMANCE.
When loading products make certain that:
• they are similar in size and type;
• the shelf load limit (160 kg/sq.m for the shelf and 225 kg/m
ded;
• the shelf load limit (480 kg/lm for the whole shelf) is not exceeded;
• products do not cover the slots that ensure the correct circulation of cool air (see fig. 9, page
14).
8. USE
This display case was designed and manufactured exclusively for the display of fresh packed food,
28
2 for the chest) is not excee-