Electrolux WA71-304 Serie Mode D'emploi page 17

40. Remove any plastic packaging from the new fabric cover to be used.
41. Starting at the top left corner of the front panel, tuck the elastic band behind the
panel and while holding that corner in place work your way with the other hand
to the top right corner while continuously tucking the elastic band of the fabric
cover behind the edge of the panel. Now pull the fabric cover towards the bottom
edge of the panel and securely tug the rest of the fabric edge behind the bottom
part of the panel.
42. Smooth out any wrinkles on the fabric cover by pushing against the wrinkles.
43. Attach the front panel with the newly fit fabric cover back to the unit and check
the edges to ensure there is no blockage of the air inlet area.
NOTE: Customizable fabric covers are machine washable, as per the care instructions provided with the kit. It is
important that the elastic band along the edges of the fabric cover is unbroken and tight as it helps ensure an optimum
flow of air into the unit, with minimal decrease in performance. If you notice that the elastic band is broken or very
loose, it is time to replace the fabric cover.
FEET CUSTOMIZATION
The thermoplastic elastomer (TPE) feet are attached to the unit by way of inbuilt
screws. The feet – like the top handle – are detachable. Follow the steps below to
attach or replace an existing set of feet.
44. Place the unit flat on its back, so the front panel faces the ceiling. Unscrew the
existing feet, if any, by twisting counterclockwise.
45. Remove any protective plastic covering the new set of feet.
46. Gently nudge the inbuilt screw of the new feet into the cavity at the bottom of
the unit and secure them by twisting clockwise till you meet some resistance.
47. Test out the stability of the feet by placing the unit back upright and lifting it
about 5-6 cm above the ground and giving it a gentle shake.
www.electrolux.com 16