HAMPTON BAY 99919C Guide D'utilisation Et D'entretien page 8

Assembly - Hanging the Fan
1
Attaching the fan to the electrical
box
WARNING: To reduce the risk of fire, electric shock or personal
injury, mount to an outlet box marked "Acceptable for fan
support of 15.9 kg (35 lbs) or less", and use the screws
provided with the outlet box.
NOTE: The mounting bracket (A) is designed to slide into place on
an outlet box with the outlet box screws (TT) installed.
□
Loosen the two mounting screws (TT) in the outlet box.
□
Pass the 120-Volt supply wires through the center hole in the
mounting bracket (A).
□
Slide the mounting bracket (A) on to the mounting screws (TT)
and center the mounting bracket (A) in relation to the outlet box.
If necessary, use leveling washers (not included) between the
slide-on mounting bracket (A) and the outlet box. The flat side of
the slide-on mounting bracket (A) should face toward the outlet
box, as shown.
□
Securely tighten the two mounting screws (TT).
3
Connecting the safety cable
□
Turn the wood screw (KK) (not provided) into the ceiling.
□
Place the looped end of the safety cable (S) onto the wood
screw and then tighten the screw firmly, or connect the
safety cable directly to the outer joist.
2
Hanging the fan
□
Carefully lift the fan-motor assembly (E) up to the slide-on
mounting bracket (A).
□
Insert the ball portion of the ball/downrod assembly into
the socket of the slide-on mounting bracket (A).
□
Turn the ball/downrod (B) assembly clockwise until it is
seated with the tab of the slide-on mounting bracket (A)
aligned with the slot in the ball.
KK
S
8
A
B
C
D
E
A