VONROC CH513AC Traduction De La Notice Originale page 6

EN
Starting the convector panel heater (fig. B)
• The heater is equipped with two heating
elements which can be independently switched
on or off.
• The heating power can be adjusted in three
steps by enabling and disabling the individual
heating elements. Refer to the table below for
the available settings:
750W switch
Heating power
(2a)
Heating off Off
750W On
1250W Off
2000W On
• Additionally, the CH514AC / CH514AC_GREY /
CH514AC_WHITE is equipped with a fan to
improve convection. The fan may be switched
on/off by using the corresponding switch (3)
Constant room temperature
The heater starts and stops automatically to keep
the room temperature constant. Once the ambient
temperature in the room reaches the desired
target temperature, the heating element will be
switched off. Once the ambient temperature starts
to decrease, the heating element will be switched
on again.
Automatic overheat-safety control
This heater is equipped with an internal safety
thermostat and overheat protection circuit. When
a potential overheat temperature is reached, the
system will automatically shut the heater off.
Storing the convector panel heater
Always let the heater cool down completely before
moving or storing the heater. Make sure the heater
is unplugged from mains power while in storage.
Warning. Do not store the machine in a wet
environment. Protect the machine from
dust while in storage.
After a prolonged time in storage, always check to
make sure the heating element is clean and free
from dust before using the heater again.
6
5. MAINTENANCE
Cleaning
1250W switch
• Wipe the enclosure with a soft cloth. For very
(2b)
dirty parts, wipe with a damp cloth, then use
Off
a clean, dry cloth to fully dry. Be careful not to
let any water enter the inside of the appliance
Off
• In order to protect the heater, don't splash
On
water onto the heater, and never use chemical
On
solvents or aggressive cleaning products.
Storage
• Allow the heater to cool down completely before
storing it.
• Store the heater in a dry, well ventilated space
ENVIRONMENT
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EU
for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that
are no longer usable must be collected separately
and disposed of in an environmentally friendly way.
Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.
Let the machine cool down completely
before cleaning.
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
WWW.VONROC.COM