ZAPTEC Pro T2S Manuel D'utilisation page 19

Cable
Zaptec Pro T2S needs a Type 2 charging point
in order for you to be able to charge
How to Start Charging
1. Check that the status indicator (Z) is illuminated green.
2. Remove the protective cover to gain access to the electrical outlet.
3. Attach the charging connector to the Zaptec Pro T2S.
4. Attach the charging connector to your vehicle.
5. The status indicator will flash blue once charging has started.
Charging current may vary depending on the capacity of the installation and
the number of active charging stations.
How to Start Charging with Authentication
Charging with authentication requires you to have registered a user profile via Zaptec
Portal and for your user profile to have had access granted to them (via Zaptec Portal)
to the charging station/facility. The charging pass is linked to your user.
For details on how to set this up, see the section Connecting a Charging Pass
to Your User.
The recommended authentication method is to use a charging pass.
Start charging with an authentication RFID tag/charging card:
1. Follow steps 1–4 in How to Start Charging.
5. The status indicator (Z) will now flash yellow to indicate that it is awaiting
authentication.
6. Hold the charging pass up to the RFID zone; see the illustration in the section
Zaptec Pro T2S.
7. The status indicator will flash green once authentication is approved.
8. The status indicator will flash blue once charging has started.
If the status indicator is flashing red, see the Troubleshooting section for further details.
English
19