ROBENS FIRE MIDGE TI. COOK SET Mode D'emploi page 2

I N S T R U C T I O N I N S T R U C T I O N
2
INSTRUCTION MANUAL
2.
1. Burner
2. Pot support
3. Air intake
4. Flame control knob (tap)
5. Gas valve
6. Seal
3.
6.
INTRODUCTION:
Category: Vapour direct pressure
Gas cartridge: This appliance shall only be used with
Butane-Propane mix gas cartridge (FIRE-MAPLE, FMS-G1
230g) complying to EN417. It may be hazardous to attempt
to fit other types of gas cartridges or gas cylinders
Nominal rate: 185 g/h 2.6kW
Injector: 0.27mm (marked: "27")
USE OUTDOORS ONLY
SAFETY INFORMATION:
Check that seals (between the appliance and the gas
cartridge (6.)) are in place and in good condition before
connecting to the gas cartridge.
Do not use the appliance if it has damaged or worn seals
Do not use an appliance which is leaking. damaged or
which does not operate properly.
Operate only on a horizontal, non-flammable, surface.
Keep away from all flammable materials. Keep a 1.0 meter
distance to flammable materials to all sides.
Gas cartridge shall be changed in a well ventilated location,
preferably outside, away from any sources of ignition, such as
naked flames, pilots, electric fires and away from other people.
If there is a leak on your appliance (smell of gas), take
it outside immediately into a well-ventilated flame free
location where the leak may be detected and stopped. If
1.
you wish to check for leaks on your appliance, do it outside.
Do not try to detect leaks using a flame, use soapy water.
INFORMATION FOR ASSEMBLY AND USE:
4.
Do not leave a fully assembled gas stove unsupervised
– especially when lit or cooling. Keep it out of reach of children.
5.
Do not touch the hot burner when in use or after use.
Disconnect the gas stove from the gas cartridge, when
storing the stove. Let the stove cool, before storing it.
LIGHTING THE STOVE:
1. Unfold the pot supports (2.).
2. Completely close the gas feed by turning the flame
control knob (4.) to the right (clockwise) to OFF position.
3. Remove the protective plastic cap from the gas cartridge
and carefully screw the cartridge on the gas valve
(5.). – care should be taken for a little gas will be lost
to the atmosphere at this point. Do not overtighten for
this may damage the stove's dual leak-proof gasket that
prevents leakage.
4. Turn the flame control knob (4.) to the left (counter-
clockwise) twice. Place a naked flame around 1-3cm
from the burner and the gas should ignite immediately.
5. A normal flame should be stable and burn upward with
a blue or saffron yellow colour depending on flame
control.
Turn the flame control knob (4.) clockwise to reduce the
flame, turn the knob counter-clockwise to increase the flame.
If you experience flaring (high yellow flames), eq. if moving the
stove while lit, turn down the flame and wait a few seconds.
Slowly adjust the flame up again to the desired level.
Regularly inspect the integrated gas seal for damage.
Apply warm soapy water at the joint and junction of the
equipment to highlight leaks through the formation of
bubbles. If you hear or smell gas don't attempt to ignite the
appliance if you can hear or smell leaking gas. If you smell
gas: Do not attempt to ignite equipment; Put out all flames;
Disconnect fuel supply.
CHANGING THE GAS CARTRIDGE:
Check that the stove is extinguished before disconnecting
the gas cartridge.
Let the stove cool down completely.
Completely close the gas feed by turning the flame control
knob (4.) to the right (clockwise) to OFF position.
Carefully unscrew the cartridge from the gas valve (5.), by
turning it counter-clockwise – care should be taken for a
little gas will be lost to the atmosphere at this point.
For safety and to protect the environment, dispose of an
empty canister responsibly and separate from other waste.
Do not crush or throw the cartridge into a combustion source.
MAINTENANCE AND REPAIR:
When the pressure falls, gas cannot ignite. Check whether
there is fuel remaining inside the gas cartridge – you will
hear and feel liquid gas move when you shake a cartridge.
If gas remains the burner may be clogged. Clean away dirt
using a cloth dipped methyl alcohol.
Blow through the air intake to clean the burner and jet. Do
not insert any use any pin into the jet for this may cause
damage, leading to a safety hazard.
Reinstall and firmly screw down the burner to ensure an
airtight seal. Reinstall the gas cartridge according to the
described operation procedures.
Regularly inspect the integrated gas seal for damage.
Apply warm soapy water at the joint and junction of the
equipment to highlight leaks through the formation of
bubbles. If you hear or smell gas don't attempt to ignite the
appliance if you can hear or smell leaking gas. If you smell
gas: Do not attempt to ignite equipment; Put out all flames;
Disconnect fuel supply.
To avoid creating a safety hazard and invalidation any warranty
do not in any way attempt to maintain, modify, disassemble
and repair your stove unless covered by this manual.
USE & CARE INSTRUCTIONS FOR TITANIUM POT & LID:
• Do not let the pot "pre-heat" more than a minute or
two on the burner. The titanium heats up quickly and
just sitting on the heat can cause deformation and
discoloring to your pot.
• Use a liquid dish detergent and a soft dish cloth or
sponge to clean the pot and lid.
• To deal with burned residue which can't easily be
removed by washing it, fill the pot with water and bring
the water to a boil to release it, then proceed with
normal washing.
• Avoid using abrasive cleaners and scouring pads, such
as steel wool, on the pot and lid. These products can
damage the finish.
• Dry the pot and lid completely before you store it.
Use the mesh bag for storage.
For spare parts and repair service, contact Oase Outdoors
+45 70 22 85 00 or info@robens.de
3