Nakayama PB7230 Mode D'emploi page 4

EN
• Never store the equipment with gasoline in the tank inside a building where fumes can reach a flame or spark.
• Allow the engine to cool before storing in any enclosure.
• To reduce the fire hazard, keep the engine, exhaust muffler and gasoline storage area free of grass, leaves, or excessive grease.
• If the fuel tank has to be drained, this should be done outdoors.
Special safety warnings
• Grip the handles of the tool firmly with both hands. Stop the tool before pausing or stopping work.
• Always be sure to maintain a steady, even posture while working.
• Maintain the speed of the engine at the level required to perform cutting work and never raise the speed of the engine above the level necessary.
• If grass gets caught in the blade during operation, or if you need to check the unit or refuel the tank, always be sure to turn off the engine.
• If the blade touches a hard object like a stone immediately stop the engine and check the blade for signs of damage. If damage is observed on the blade
replace it with a new identical one.
• If someone calls out while working, always be sure to turn off the engine before turning around.
• Never touch the spark plug or spark plug cord while the engine is in operation. Doing so may result in being subjected to an electrical shock.
• Never touch the muffler, spark plug or other metallic parts of the engine while the engine is in operation or immediately after shutting down the engine.
Doing so may result in serious burns.
INTENDED USE
• This brush cutter is intended only for cutting grass. Any other use is not permitted.
ASSEMBLY INSTRUCTIONS
Connecting the aluminum shaft to the motor
1. Align the four holes on the shaft reducer with the four motor housing holes and insert the screws into the holes. Tighten the screws using the appropriate
Allen key. (Fig. 1-2)
Installing the handle
1. Remove the 4 screws on the bracket and remove the upper plate.
2. Place the handle into the fixing slot, place the upper plate back on the bracket and tighten the 4 screws to firmly secure the handle.
Fig. 3
Installing the safety guard
1. Align the two holes on the board with the holes on the safety guard.
2. Insert the two combination screws into the holes and tighten them securely with the Allen key.
Assembling the cutting head
Nylon cutting head
4
Fig. 1
Fig. 4
Fig. 7
WWW.NIKOLAOUTOOLS.COM
Fig. 2
Fig. 5
Fig. 8
Fig. 6