Breville the Bit More BTA720XL Manuel D'instructions page 9

Functions
NOTE
This toaster is electronically controlled and will
not operate until the toaster is plugged into a
110/120 volt power outlet.
Before first use, remove any packaging material
or promotional labels attached to your toaster.
1. Insert the power plug into a 110/120V
power outlet. The LED toasting progress
indicator will illuminate from left to right,
then align to the selected browning setting
(indicated by the position of the browning
control slide). The toaster will revert to
stand-by mode after a few minutes if a
button is not pressed or the browning
control slide is not adjusted.
NOTE
When using the toaster for the first time, we
suggest toasting on the maximum setting
without bread. The toaster may emit a thin
smoke or distinct odor on initial use. This is
normal and not detrimental to the performance
of the toaster.
2. Place bread, bagels, English muffins etc into
each of the toasting slots. Ensure items for
toasting are not too large or too thick to fit
in the toasting slots.
3. There are 12 browning settings ranging
from '1' (lightest) to '5' (darkest). Select
the desired browning setting by adjusting
the browning control slide on the front
of the toaster. The LED toasting progress
indicator will illuminate and align to the
selected browning setting (as indicated by
the position of the browning control slide).
NOTE
When toasting bread for the first time, it is
suggested to toast on browning setting '3' (7
LED's illuminated). Various types of bread and
personal preference may require a different
browning setting. For example, raisin toast
and white light-textured breads may require
a lighter setting, while heavier textured rye
breads may require a darker setting.
4. To start the toasting process, press down
the lever until it locks into place. The LED
toasting progress indicator (above the
selected browning setting) will flash and
start to gradually count down.
NOTE
Toasting can be stopped at any time by
pressing the CANCEL button. This will cancel
the operation and the carriage will move to the
raised position.
5. Once the toasting cycle is complete
the toast ready alert will sound (refer
to TOAST READY ALERT, page 13, to
adjust the volume). Remove the toast.
The LED toasting progress indicator will
re-illuminate to the previously selected
browning setting for a few minutes before
entering stand-by mode.
NOTE
To re-activate the toaster from stand-by mode,
press any button or move the browning control
slide. The LED toasting progress indicator will
re-illuminate.
WARNING
Do not leave the toaster unattended when in
use as toast may jam.
9