VEVOR TS26 Mode D'emploi page 15

DETECTING METALLIC OBJECT WITH THE DETECTOR
After you finish all the tests mentioned above, you can start to detect metallic
objects.
Turn on the detector, and set it in the ALL METALS mode. And be far away from
any external interference source.
During detection, keep the search coil height approximately 3cm to 5cm above the
ground and parallel to the ground at all times for best detection results, walk slowly
as you scan the search coil slowly in a straight line from side to side.
When you detect a metallic object, you can use the DISCRIMINATION mode to try
further identification or discrimination, if necessary.
Metal detection is a careful, difficult job. Because there may be iron nails, metallic
oxides, and metal scraps in soil, it may be necessary to perform detection many
times in the same location to get an accurate result, especially in an area where
the soil contains complex mineral substance constituents.
- 13 -