Mains Supply; Important; Areas Of Use; Cleaning The Impeller - Pattfield Ergo Tools E-STP 8517 Mode D'emploi D'origine

Anleitung_E-STP_8517_SPK7__ 02.07.13 11:43 Seite 9
Please note!
You should never install the pump by suspending it
unsupported from its delivery pipe or power cable.
The submersible motor pump must be suspended
from the specially provided handle or be placed on
the bottom of the shaft. To guarantee that the pump
works properly, the bottom of the shaft must be kept
free of sludge and dirt of all kinds.
If the level of water sinks too far, any sludge in the
shaft will dry out quickly and stop the pump from
starting up. It is necessary, therefore, to check the
submersible motor pump regularly (by carrying out
start-up tests).
The floater is adjusted in a way that the pump can
immediately be started
Note!
The pump shaft should have minimum dimensions of
40 x 40 x 50 cm, so that the floating switch can move
freely.

5. Mains supply

Your new submersible pump is equipped with a
shock-proof plug according to regulations. The pump
is designed to be connect-ed to a 230 V ~ 50 Hz
safety socket.
Make sure that the socket is sufficiently secured
(min. 6 Amp.) and is in excellent condition. Introduce
the plug into the socket and the pump is ready to go.
Important Note!
If the mains cable or plug suffers any damage from
external action, repairs to the cable are prohibited.

Important!

This work may only be performed by a qualified
electrician or your ISC GmbH Customer Service.

6. Areas of use

This pump is used primarily as cellar pump. When
installed in a shaft, this pump provides protection
from flooding.
They are also used wherever water has to be moved
from one place to another, e.g. in the home,
agriculture, horticulture, plumbing and many other
applications.
7. Setting to work
After having read these instructions carefully, you
can set your pump to work, reconsidering the
following items:
● Check if the pump rests on the ground of the
shaft.
● Check of pressure cord has been attached
properly .
● Check if electrical connection is 230 V ~ 50 Hz.
● Check if socket is in good condition.
● Make sure that water and humidity can never
come to the mains supply.
● Avoid pump running dry.
8. Maintenance guidelines
This submersible pump is an approuved,
maintenance-free high quality product, which is
subject to severe final controls.
We recommend, regular inspection and maintenance
to ensure long equipment life and uninterrupted
operation.
Important! Note!
● Remove the mains plug before all maintenance
work.
● In the event that the pump is often transported in
the course of operation, it should be cleaned out
with clear water after every use.
● In case of stationary installation, the function of
the loating switch should be checked every 3
months.
● All fibrous particles which may have built-up inside
the pump housing should be removed with a water
jet.
● Every 3 months the shaft ground and as should be
cleaned from mud.
● Remove deposits on the floater with clear water.

Cleaning the impeller

If excessive deposits collect in the pump case you
must dismantle the bottom part of the pump as
follows:
1. Undo the 4 screws from the bottom of the intake
cage.
2. Remove the intake cage from the pump case.
3. Clean the impeller with clear water.
Important! Do not put down or rest the pump
onthe impeller!
4. Assemble in reverse order.
GB
9