Toshiba REGZA C300 Serie Mode D'emploi page 7

Connecting external equipment
Before connecting any external equipment, turn off all main power switches. If there is no switch
remove the mains plug from the wall socket.
SCART 2 (EXT2)
SCART 1 (EXT1)
decoder*
media recorder
Aerial cables:
Connect the aerial to the socket on the rear of the television.
If you use a decoder* and/or a media recorder it is essential
that the aerial cable is connected through the decoder
and/or through the media recorder to the television.
SCART leads:
Connect the video recorder IN/OUT socket to the television.
Connect the decoder TV socket to the television. Connect
the media recorder SAT socket to the decoder MEDIA REC.
socket.
Before running Auto tuning put your decoder and media
recorder to Standby.
The phono sockets alongside the COMPONENT VIDEO
INPUT sockets will accept L and R audio signals.
In addition there is a fixed external audio ouput which
enables the connection of a suitable Hi-Fi unit.
HDMI™ (High-Definition Multimedia Interface) is for use with
a DVD, decoder or electrical equipment with digital audio
and video output.
REGZA-LINK will only work through HDMI when using other
Toshiba equipment with REGZA-LINK capability.
COMPONENT VIDEO (EXT3)
MEDIA REC.
TV
IN/OUT SAT
7
FIXING STRAP
HDMI™ INPUT
SOCKETS
NOTE: It is recommended that an HDMI cable with the
HDMI logo ( ) is used. When connecting other
equipment to this television if the connection is capable of
1080p a Category 2 cable will be required. Conventional
HDMI/DVI cable may not work properly with this mode. It is
recommended that DVI cable or DVI/HDMI adapter with
cable is less than 2m long.
NOTE: Although this television is able to connect to HDMI
equipment it is possible that some equipment may not
operate correctly.
A wide variety of external equipment can be
connected to the back of the television, therefore the
relevant owners manuals for all additional
equipment must be referred to.
We recommend SCART 1 for a decoder and SCART 2 for a
media recorder. If connecting S-VIDEO equipment, set the
INPUT for EXT2. See page 27.
If the television automatically switches over to monitor
external equipment, return to normal television by pressing
the desired programme position button. To recall external
B
equipment, press to select between TV, EXT1, EXT2,
EXT3C, HDMI1, HDMI2 or PC.
HDMI, the HDMI logo, and High-Definition Multimedia Interface are
trademarks or registered trademarks of HDMI Licensing, LLC.
CABLE HOLDER