Publicité
Les langues disponibles
Les langues disponibles
Start-up
•
Click the "Add devices" button on the right-hand side of the
screen.
•
To activate pairing mode, click "Pairing HmIP device" in the next
window. The pairing mode of the Central Control Unit will be
activated for 60 seconds. An information box shows how much
pairing time remains.
•
After connecting the power supply, the device is active for 3 min-
utes.
You can manually start the pairing mode for another 3 minutes by
pressing the system button (D) briefly using a pointed object (e.g. a
pen) (see figure 8).
•
Wait until pairing is completed.
•
If pairing was successful, the LED (D) lights up green. The device
is now ready for use.
•
If the LED lights up red, please try again.
•
After a short time, the newly added device will appear in the in-
box of your software interface.
Newly connected devices and the corresponding channels are ready for
operation and configuration only after they have been configured in the
34
inbox. You will find further information in the Homematic IP Wired Instal-
lation Guide at www.homematic-ip.com.
For operating without an Internet connection, please select the op-
tion "Adding Homematic IP device without Internet connection".
Enter the SGTIN and key of the device into the corresponding fields.
You will find the SGTIN and the key on the supplied sticker. Keep the
sticker in a safe place.
5.3.2
Connecting to the Homematic IP cloud via Wired access point
If you want to control your Homematic IP Wired devices flexibly via the
smartphone app, they can be connected to the Homematic IP cloud. To
do this, proceed as follows:
•
Open the Homematic IP app on your smartphone.
•
Connect the Homematic IP Wired Access Point via the smart-
phone app to the Homematic IP cloud, as described in the cor-
responding manual.
•
Select the menu item "Add device".
•
After connecting the power supply, the device's pairing mode is
active for 3 minutes.
You can manually start the pairing mode for another 3 minutes by
pressing the system button (D) briefly using a pointed object (e.g. a
pen) (see figure 9).
•
Your device will automatically appear in the Homematic IP app.
•
To confirm, enter the last four digits of the device number (SG-
TIN) in your app or scan the QR code. The device number can be
found on the sticker supplied or attached to the device.
•
Wait until pairing is completed.
•
If pairing was successful, the LED (D) lights up green. The device
is now ready for use.
•
If the LED lights up red, please try again.
•
Select the desired solution for your device.
•
In the app, give the device a name and allocate it to a room.
Start-up
35
Publicité
