LG DLEX9000 Serie Manuel Du Propriétaire page 35

Custom Program
If you have a special combination of settings that you
use frequently, you can save these settings as a CUSTOM
PROGRAM.
to save a custom program:
1. Turn on the dryer and turn the cycle selector knob to
select the desired cycle.
2. Use the cycle modifier buttons to adjust the settings
for that cycle.
3. Press the cycle option button(s) for the option you
would like to add. A confirmation message will be
shown in the display.
4. Press and hold the PGM Save button for 3 seconds.
NOTE
You may save only one custom program at a time.
Pressing and holding the PGM Save button will
overwrite any previously saved custom program.
recalling a custom program
1. Turn on the dryer.
2. Press the CUSTOM PGM button.
3. Press and hold the Start button to start the cycle.
Steam Functions
LG's new steam technology allows you to inject fabrics
with a swirling jet of hot steam to refresh clothes.
Simply select the STEAM FRESH™ cycle, or you can add a
steam option to selected cycles.
tm
the steam fresH cycle
STEAM FRESH™ uses the power of steam to quickly
reduce wrinkles and odor in fabrics. It brings new life to
wrinkled clothes that have been stored for an extended
time and makes heavily wrinkled clothes easier to iron.
STEAM FRESH™ can also be used to help reduce odors in
fabrics.
NOTE
• The TurboSteam option is activated by default when
the Steam Fresh™ or Steam Sanitary™ cycles are
selected.
• Depending on the load (quantity of items), you may
change the amount of time for the cycle by pressing
the MORE TIME or LESS TIME button. The display will
show 1, 3, 5, or . 3 means 3 or fewer items, 5 is
for 4 or 5 items, and
as a comforter.
indicates a large load such
tm
using the steam fresH
1. Turn on the dryer and turn the cycle selector knob to
select the STEAM FRESH ™ cycle.
2. To add an option function, select TurboSteam, or
WRINKLE CARE.
3. Depending on the load (quantity of items), steam time
can be changed by pressing the MORE TIME or LESS
TIME buttons.
4. Press and hold Start to start the cycle.
adding steam to a standard cycle
1. Turn on the dryer and turn the cycle selector knob to
select the Normal, Perm. Press, or Heavy Duty cycle.
2. Use the cycle modifier buttons to adjust the settings
for that cycle.
3. Press the TurboSteam button.
4. Press and hold Start to start the cycle.
NOTE
• After the TurboSteam option is selected in TIME DRY,
the MORE TIME or LESS TIME buttons will change the
steam time ONLY.
• After pressing and holding Start, the MORE TIME or
LESS TIME buttons are disabled.
tm
the steam sanItarY cycle
TM
The STEAM SANITARY cycle is ideal for sanitizing non-
washable items quickly and easily using only steam.
This cycle is recommended for use with cotton and
polyester materials only. (Do NOT use for urethane foam,
down feathers or delicate items)
NOTE
• TurboSteam can only be selected if the Energy Saver
is turned off.
• TurboSteam can only be selected if the Very or More
dry level is selected.
35
OPERATION
cycle