Blaupunkt 5DA36453 Manuel D'utilisation Et Notice D'installation page 26

en Installation instructions
Preparing the appliance
Insert the holders for the wall edging strip on the
1.
outside rear of the appliance into the cut-outs and
fold them in to the centre of the unit.
2. Use the screws provided to secure the handle strip
to the filter pull-out.
Connect the enclosed power cord to the appliance
3.
and secure the stain relief.
Screw the two angle brackets to the appliance. Note
4.
the position of the screws. Screw in the screws until
8 mm of the threaded section is still protruding.
26
Installing the appliance
Use the angle brackets to hang the appliance on
1.
the screws, align it and tighten it.
Appliance width 90 cm: Pull the filter pull-out out
2.
completely towards the front. Also use two screws
each on the left and right to screw the appliance to
the side upper cabinets from below.
Adjust the wall closing strip to the clearance
3.
between the appliance and the wall.
Snap the wall closing strip into the holders.
4.
Fit the grease filters.
5.
Establish the pipe connection.
6.
Establish the electrical connection.
7.