BorMann BEM1450 Manuel D'utilisation page 4

EN
During the mixing process, slowly move the machine around the mixing container. This should be continued until all of the mixing material has been mixed.
Once the mixing process has been completed, clean the mixing paddle (6) to stop the build up of dirt and residue.
Starting current limiting
The electronically controlled soft start ensures
That the machine starts smoothly. This also prevents spray from thin liquids when the tool is switch on.
The lower starting current means the a 16A fuse is large enough for the machine.
Idling speed reduction
The electronic control lowers the speed of the machine during idling. This reduces noise and wear on the motor and gears.
Constant electronics
The constant electronic controller keeps the speed virtually constant during idling and under a load.
This guarantees that materials are mixed uniformly
Electronic overload protection
An electronic overload device protects the motor against damage when the tool is under an extreme load. In this case, the motor stops and only starts up
again when the feed is reduced or the load re-moved.
Temperature-dependent overload protection
To prevent the motor from overheating under an Extreme continuous load, the safety electronics switches the motor off when it reaches a critical tempera-
ture.
After a cooling-down time of around 3-5 min.
The machine is ready for operation at full load.
If the tool is warm from operation, the temperature dependent overload protection will respond earlier
Note: The numbers shown in brackets refer to the pictures shown in the Machine
Description section of the booklet.
Environmental protection
Safe Disposal
Instructions for the protection of the environment.
The machine contains valuable materials. Take the discarded apparatus and accessories to the relevant recycling facilities.
Storage
The machine should be stored in a dry area which is not exposed to extreme temperatures.
Health And Safety
Vibration
Some vibration from the mixing operation is transmitted through the handle to the operator's hands.
PPE (Personal Protective Equipment)
Suitable PPE must be worn when using this equipment i.e. Safety Goggles, Gloves, Ear Defenders, and Steel Toe capped footwear.
Wear clothing suitable for the work you are doing. Tie back long hair and remove any jewellery which may catch in the equipment's moving parts.
Electric Machines
Electricity can kill! Always ensure that the machine is disconnected from the power supply before carrying out any maintenance/repairs. Never use the ma-
chine in wet conditions. Inspect tool cord and anti-drop plug periodically and, if damaged, have them repaired by an authorized expert.
Dress properly
Rubber gloves and non-slip footwear are recommended when working outdoors. Wear protective hair covering to contain long hair. Use safety glasses.
Use a mask if working operations are dusty.
4
WWW.NIKOLAOUTOOLS.COM