Home Decorators Collection SHANDEL CF48SHA3BN Guide D'utilisation Et D'entretien page 2

Table of Contents
Table of Contents ................................................................ 2
Safety Information ............................................................... 2
Warranty ............................................................................... 3
Pre-Installation .................................................................... 3
Installation ........................................................................... 6
Safety Information
READ AND SAVE THESE INSTRUCTIONS.
1.
To reduce the risk of electric shock, ensure the electricity has
been turned off at the circuit breaker or fuse box before you
begin.
2.
All wiring must be in accordance with the National Electrical
Code ANSI/NFPA 70-1999 and local electrical codes. Electrical
installation should be performed by a qualified licensed
electrician.
3.
The outlet box and support structure must be securely mounted
and capable of reliably supporting
Listed outlet boxes marked "Acceptable for Fan Support of
lbs. (15.9 kg) or less."
4.
The fan must be mounted with a minimum of 7 ft. (2.1 m)
5. Do not operate the reversing switch while the fan blades are
in motion. You must turn the fan off and stop the blades before
you reverse the blade direction.
6.
Do not place objects in the path of the blades.
7. To avoid personal injury or damage to the fan and other items,
use caution when working around or cleaning the fan.
8.
Electrical diagrams are for reference only. Light kits that are
not packed with the fan must be UL-listed and marked suitable
for use with the model fan you are installing. Switches must be
UL General Use Switches. Refer to the instructions packaged
with the light kits and switches for proper assembly.
9. After making electrical connections, spliced conductors should
be turned upward and pushed carefully up into the outlet box.
The wires should be spread apart with the grounded conductor
and the equipment-grounding conductor on one side of the
outlet box.
10. All setscrews must be checked and retightened where
necessary before installation.
11.
This device contains licence-exempt transmitter(s)/receiver(s)
that comply with Innovation, Science and Economic Development
Canada's licence-exempt RSS(s). Operation is subject to the
following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interfer
ence that may cause undesired operation of the device.
35 lbs. (15.9 kg). Use only CSA/UL
35
Assembly .............................................................................. 7
Operation ........................................................................... 12
Care and Cleaning .............................................................
Troubleshooting ................................................................. 13
WARNING: To reduce the risk of personal injury, do not bend the
blade brackets (also referred to as flanges) during assembly or
after installation. Do not insert objects in the path of the blades.
WARNING: Suitable for use with solid-state speed control
(MR181A-3 only).
WARNING: To avoid possible electrical shock, turn the electricity
off at the main fuse box before wiring. If you feel you do not have
enough electrical wiring knowledge or experience, contact a
licensed electrician.
WARNING: Electrical diagrams are for reference only. Optional
use of any light kit shall be UL-listed and marked suitable for use
with this fan.
WARNING: To reduce the risk of fire, electric shock, or personal
injury, mount fan only to an outlet box marked acceptable for fan
support and use mounting screws provided with the outlet box.
Most outlet boxes commonly used for the support of lighting
fixtures are not acceptable for fan support and may need to be
replaced. Consult a qualified electrician if in doubt.
2
13