senya PO2018262 Notice D'utilisation page 31

3.2. Setting the time
Once the appliance is plugged to a wall outlet:
- Press the "PROG" (programming) button once. The word "CLOCK" appears at the top right of
the screen.
- Press the "HOUR" and "MIN" button to set the time. Press the button once to set the time by
intervals of 1. Keep the "HOUR" button pressed for 3 seconds to set the time faster.
N.B.:
- The time cannot be adjusted while the appliance is running.
- If there is a power cut or if you unplug the appliance, the display will revert to "12:00".
3.3. Coffee preparation
1. Open the lid and fill the water reservoir with cold water according to the graduations on
the left side of the appliance without exceeding the maximum level.
2. Add the coffee to the permanent filter supplied in the filter holder using the measuring
scoop provided. Add 1 teaspoon of ground coffee per cup of coffee and adjust the
quantity to suit your taste.
3. Close the lid and plug the appliance to a power source. The screen displays « 12:00 ».
4. Place the coffee pot on the heating plate, making sure that it is positioned horizontally.
Aroma selector
The aroma selector is used to adjust the intensity of your coffee by allowing you to choose between
3 infusion speeds:
-
One bean « » : mild flavour
-
Two beans «
-
Three beans«
The coffee maker is set to mild flavour intensity by default: the screen shows one bean «
To adjust the flavour to brew coffee of the desired intensity, press the "MODE" button as many times
as necessary to select the number of beans coresponding to the intensity required.
5. Press the "ON/OFF" button once. The red indicator light will light up. The coffee begins
to flow into the coffee pot after a few seconds.
6. When the coffee is ready, the heating plate stays on until the appliance is switched off.
Otherwise, it will switch off automatically after 5 minutes max. To switch off the coffee
maker, you can simply press the "ON/OFF" button.
3.4. Adjusting the programme
Once the device is plugged to a wall outlet, to adjust the time at which you want the coffee maker to
start preparing the coffee:
1. Press the "PROG" (programming) button twice. The word "TIMER" will appear in the top
left of the screen.
2. Press the "HOUR" and "MIN" button as many times as necessary in order to settle the
required hour.
3. Wait for a few seconds until the screen shows the current time.
4. Prepare the water reservoir and the coffee.
5. Press the "ON/OFF" button twice. The white "PROG" indicator light switches on. The
coffee maker will start at the programmed time.
6. After preparing the coffee, if you leave the coffee maker on, it will turn off at the end of
5 minutes max. If you want to switch it off immediately, press the "ON/OFF" button to
switch off the coffee maker.
» : strong flavour
» : intense flavour
».