Weston 65-0650-W Mode D'emploi page 10

USING THE ROLL HOLDER & CUTTER
1. To create bags using the roll holder, remove the roll holder rod from the
cilps at the back of the vacuum sealer (FIGURE 6).
2. Slide the rod through the center opening of the roll (will hold bags up to
11" wide).
3. Fold the roll holder arms out and rest the rod in the slots on the roll holder
arms, carefully lining up the notches in the rod with the slots in the arms.
4. It is easier to cut bags from the roll when the bags are rolled over the roll
(as opposed to under the roll) (FIGURE 7).
5. Move the bag cutter towards the lid and pull the vacuum bag over the
cutter slot until you have reached the desired length.
6. Move the bag cutter back over the top of the bag roll, making sure the
blade is to one side.
7. Slide the blade across the bag roll to cut your roll into your custom bag
size (FIGURE 8).
FIGURE 6
FIGURE 7
10
FIGURE 8