Lea LE581504H Mode D'emploi page 44

Press on switch (9).
The motor will run as long as you press the switch.
Switch Off: Release switch (9)
LE583008V(Fig.23)
Switch on:
Press the green button (I)
Switch Off:
Press the red button (0)
Never use the machine if the On/Off switch is not working properly.
Immediately have any damaged switch repaired or replaced by qualified personnel to
avoid a danger.
6.6 Two-hand operation control
LE581504H(Fig.22)
This log splitter is equipped with "ZHB" control system that requires to be operated by both
hands of the user:
- the right hand controls the pushbutton switch (9).
- the left hand controls the hydraulic control lever (1)
The log splitters will stop upon absence of either hand.
Only after both hands release the controls, the log pusher starts to return backward to its
starting position.
1. Press the On/Off switch (9). Wait a few seconds until the engine reaches its operating
speed and the pressure is generated in the hydraulic pump.
2. Lower the control lever (1).
The ram pushes the log against the wedge. The log is split.
3. Release the control lever (1) and the switch (9), the ram returns to its initial position.
LE583008V(Fig.24)
Remarques:
- Ne pas relâcher les poignées de commande tant que le fendeur n'a pas terminé sa course
et que la buche soit fendue.
- Le fendeur s'immobilise dès que vous relâchez une poignée de commande.
1. Press on Green button (6).
Wait a few seconds until the engine reaches its operating speed and the pressure is generated
in the hydraulic pump.
2. Place log onto support table (14).
Only cut wood along fibers.
3. Firmly hold log with log holder claws (18).
4. Lower the control levers to start the splitting (see Fig.24).
5. Release both handles to return the splitting wedge to the upper position.
Remarks:
36