THOMSON DP9200 Mode D'emploi page 25

USING AN SD/MMC/MS MEMORY
CARD (not supplied)
PLAYBACK OF A SD/MMC MEMORY CARD (not included)
The player has a memory card port to allow you to read
music (.mp3), image (.jpeg) and video (.avi) files from a
memory card. Three types of memory cards are accepted:
SD, MMC and MS.
• Insert the memory card in the slot provided for that
purpose, respecting the right way. Do not push the card
in completely. It is normal for part of the card to stick
out from the slot.
• Press SOURCE, choose the CARD mode with the
arrow keys, then ENTER to confirm.
• The content of the memory card is displayed on the
screen of the device.
The playback functions are identical to those of a USB key.
Refer to the section corresponding to the type of files to be
played.
Note:
• Do not remove the memory card when the files are
being read.
• ATTENTION: Maximum capacity supported: 32GB.
Consult the following table if there is a problem with the appliance.
Problems
Picture without sound
No sound, no picture
PORTABLE DVD PLAYER
DP9200
Solutions
• Check that the audio connectors are
connected properly.
• Check that the audio connectors are
not damaged.
• Check that the volume is high in the
VOL/CH section.
• Check that the audio parameters have
been correctly defined for the player.
• Check that the audio parameters have
been set up correctly for your television
set.
• Check that the sound has not been
turned off.
• Check that ON/OFF is set to ON.
• Check that the plug is plugged in
correctly.
• Check that the electrical cable's plug
has been plugged into the mains socket.
• Check that the indicator light (LED)
is lit up.
TECHNICAL SPECIFICATIONS
• Playback Mode: NTSC/PAL
• Disc mode: DVD,VCD, CD, MP3, CD-R, CD-RW, JPEG,
DVD+ -R/W, MPEG4,
• Resolution: = 500 lines
• Video S/N: = 65dB
• Frequency response in 96KHz fs: 20Hz-20KHz: ± 1 dB
• Audio S/N: 90dB
• Dynamic range: 80dB
• Distortion: < 0.01%
• Converter N/A: 96KHz/24bit
• Video outlet: 1Vp-p (75 Ω)
• 2.0 Outlet channels
• Power consumption: 12W
• Voltage: DC IN 12V
Note: Unit design and specifications are subject to change
without notice. The manufacturer reserves the right to make
the necessary improvements.
REPAIR AND MAINTENANCE
Problems
The remote control does
not work
"No disk" is displayed
Solutions
• Check that the
remote control's
battery is working.
• Point the remote
control towards the
player's infrared
sensor.
• Remove the
obstacles between the
remote control and the
player.
• Make sure that you
have inserted a disk in
the player.
• Check that the disk
has been inserted
correctly.
• Check that the disk
is not deformed, dirty
or scratched.
25 EN