Filex security PS310 Manuel D'utilisation page 36

User manual electronic lock PS310
5. Power supply
ock
5.1 Changing the battery
PS310/E31
As soon as the battery is almost empty (and the voltage becomes too low), the red light will flash 5 times
and a warning signal will sound several times when the door is opened. This is the warning that you need
nter] [PIN1] [Enter]
to change the battery.
utton, switched on Dual Code
Do not use rechargeable batteries, only high quality 9-volt batteries.
2
(see par.2.3).
Unscrew the battery cover on the inside of the door. Remove the battery, insert a new battery, and fit the
cover in place again. Then test opening and closing a few times with the door open.
Dual Code function
er)][Enter]
er)][Enter]
1 minute
Master Code is [0].

Install a new battery (9V, type 6LF22).
was entering [PIN2][Enter], for
e [PIN3][Enter] there are just 1

Take the cover or the box back to their location.
1

s [ G] (see par.2.3) every 5
2 Opening the lock when the Battery is
5.2 Emergency power supply
Discharged
There is an emergency power supply facility on the keyboard, in case the fitted battery becomes completely
Dual Code function
discharged. Remove the plastic cover plate with a screwdriver. While holding a 9-volt block battery firmly against

Take a new battery (9V, type 6LF22).
the '+' and '-', carry out the normal opening procedure. Then you can replace the empty battery.
nter] [PIN1] [Enter]

Take out the plastic cover for emergency power
(5), see Fig. 5.2.
ery
ed on the inner side of the
n the safe model, battery
inside the lock
.1a) or in a special pull-out
Fig. 7.2
b).

Press the new battery to emergency power pins
of the battery compartment
and fix it in this position (see Fig.5.3).
g. 7.1a. or pull out the box
Do not make the battery's contacts to the metal parts
Do you have questions about your safe, the electronic lock or is there an unexpected malfunction?
of the lock.
Please contact your local dealer.
36
7.2
USER MANUAL
battery

Install a new battery (9V, type 6LF22).

Take the cover or the box back to their location.
Opening the lock when the Battery is
Discharged

Take a new battery (9V, type 6LF22).

Take out the plastic cover for emergency power
(5), see Fig. 5.2.
Fig. 7.2

Press the new battery to emergency power pins
and fix it in this position (see Fig.5.3).
Do not make the battery's contacts to the metal parts
of the lock.
Fig. 7.3

Enter the valid code on the keypad (1).

Disconnect the emergency battery, open the
door and change the discharged battery, see
par. 5.1.
USER MANUAL