SW-Motech HDG.00.220.31700/B Instructions De Montage page 15

3
Screw the inner ends of the brackets (7/8) to the connecting plates (2/3).
Do not tighten the screws (12) yet.
Now position the brackets (7/8) according to your driving ergonomics and
tighten all screws in the following order and as specified in the mounting
instructions: (12), (5), (9).
 DANGER: If there is not enough space after installation of all
components, the brake and clutch unit must be moved a few millimeters
towards the end or middle of the handlebar!
 DANGER: After installation, make sure that all switch and control units,
especially the throttle assembly, brake lever, emergency stop switch and
clutch, function properly and are easy to use!
Also make sure that the handlebars can be fully turned in both directions. If
parts of the product come into contact with the tank or other vehicle
components when the steering wheel is at full lock, repositioning the
product or the handlebars is absolutely necessary!
Make sure that the installation complies with the vehicle manufacturer's
specifications! DO NOT ride your vehicle if the switch and control units are
not functioning correctly or cannot be operated correctly!
BEFORE every ride, carry out a complete functional check of the handlebars
and all fittings!
The content translation is automated.
© SW-MOTECH GmbH & Co. KG
MOUNTING STEP · READ AND KEEP MOUNTING INSTRUCTIONS!
6
2
12
×
8 Nm
2
13
×
2
14
×
Errors and omissions excepted
Subject to technical and design changes.