Télécharger Imprimer la page

MZ electronic KOMPASS2-868 Instructions D'utilisation page 5

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Receiver's functioning
Receiver is supplied with 2/4 relays outputs with one/two common contacts (Please check wiring diagram); common contact must
be connected to positive or negative pole, according to the polarity of the load connected;
In order to avoid overload due to short circuit, put in a 3 A fuse.
When you turn on the receiver, the green led LINE turns on and after 1 sec. the red led for programming turns on as well.
The red led keeps turned on for about 15 sec., during this time the receiver is enabled to receive a new transmitter's code and to
memorize it. It is possible to store up to 5 transmitters at the same time; whenever more than 5 transmitters are memorized, the
receiver accepts the latest code cancelling the first code received. When the red led is turned off you cannot make any TX
memorizing procedure;
The pressure of one button on the transmitter turns on the corresponding yellow led on the receiver and the operating of the
output that is concerned;
Programming Procedure
After powering the receiver when the red led is turned on steady follow these steps:
1.
2.
3.
4.
5.
6.
In order to add a new transmitter to a device that you already use, turn the receiver on and follow this procedure:
Press and keep pressed the button PROG on the receiver as long as the red led turns on, then release it.
Repeat the procedure starting from step 1
Battery replacement
Unscrew the 6 screws on the transmitter's back and take the rear part of the box away;
Replace the batteries employing exclusively 1.5V AAA batteries. Pay attention in respecting polarity; reversing batteries doesn't
damage the transmitter, but stops its functioning;
Position the rear cover and screw the 6 closing screws.
Connecting the optional external antenna
Make a 5 mm hole in the lower part of the receiver (on the right side of the hole of the connection cable) as shown in the picture 1;
Open the receiver and remove the internal antenna from the terminal board;
Run the cable of the external antenna in the hole already made and connect it to the terminal board: the cable shield must be
connected to the right contact, and the radio signal wire to the left contact (Figure 2):
Close the receiver and fix the antenna to the boat loom employing the flat washer and the nut given in equipment.
Dimensions
in mm
Fig.1
KOMPASS2-868, KOMPASS4-868
Turn the new transmitter on, pressing the button ON;
Keep the button UP pressed (it is on the left for the 2 channels version, or at the bottom on the left for the 4
channels version;
Press the button PROGR on the receiver;
Release the button UP of the transmitter;
If the code has been recognized the led blinks in succession four times, then it turns off in order to confirm that the
new transmitter has been memorized;
Verify the correct functioning of the new transmitter ;
Radio signal
wire
- 5 -
English
Cable shield
Fig.2
Rev. 01 – 2013

Publicité

loading

Ce manuel est également adapté pour:

Kompass4-868