GYS ALIEN+ 9-13G TRUECOLOR Mode D'emploi page 9

Translation of the original instructions
Uncontrolled switching or flickering:
Filter darkens and then lightens while the welding arc is present
Side of the filter is lighter than the center of viewing area
SAFETY LABEL
This label is displayed inside the welding helmet. It is important that the user understands the safety symbols signification. The list
numbers match image numbers
Legend :
A. Warning ! Beware ! There are possible dangers as per the different symbols.
1. Read the instructions carefully before using the product or before welding.
2. Do not remove the warning label and do not paint on it.
3. Follow settings instructions and maintenance of the filter, the protective screens, the headband and the hood.
4. Inspect the helmet and the UV/IR filter carefully. Replace damaged or worn parts immediately. Cracked, scratched, filter glasses and
protective screens decrease protection. Replace them immediately to avoid damaging your eyes.
5. Warning, if the UV/IR filter does not tint whilst welding or cutting, stop immediately and consult the user manual.
6. Arc radiation can cause eyes and skin burns.
6.1. Use a welding helmet with a good filtration or opacity. Wear complete protective clothing..
6.2. The helmet, filter and protective screen do not gurantee unlimited protection against, shocks, impacts, explosions or corrosive
liquid. Avoid welding or cutting in rough envirionment.
6.3. Do not weld or cut above your head with this helmet.
7. Keep your head away from the smoke-filled area. Use a forced ventilation or a local aspiration system to eliminate smoke.
8. The oxyacetylene welding-cutting, laser or gas is not authorised with this helmet.
ALIEN+ 9-13G TRUECOLOR
.
1
A
Check arc sensors are not blocked from direct access to the arc light.
It is a natural feature of 's, this symptom is not dangerous for the eyes.
However for a maximum comfort, try to keep a viewing angle of around
90°
?
EN
9
EN