GreenWorks STBA24B210 Manuel De L'utilisateur page 12

3. Insert the line into the anchor hole (24) of the spool.
4. Wind the cutting line around the spool tightly in the
indicated direction.
5. Put the cutting line in the guide slot (25).
6. Do not wind the cutting line beyond the edge of the spool.
11 TRANSPORTATION AND
STORAGE
WARNING
Remove the battery pack from the machine before
transportation and storage.
11.1 MOVE THE MACHINE
When you move the machine, you must:
• Wear gloves.
• Stop the machine.
• Remove the battery pack.
11.2 STORE THE MACHINE
• Remove the battery pack from the machine.
• Make sure that children cannot come near the machine.
• Keep the machine away from corrosive agents such as
garden chemicals and de-icing salts.
• Secure the machine during transportion to prevent
damage or injury. Clean and examine the machine for any
damage.
English
12 TROUBLESHOOTING
Problem Possible Cause
The ma- No electrical con-
chine does tact between the
not start machine and the
when you battery pack.
push the
trigger.
The battery pack is
depleted.
The lock-out but-
ton and trigger are
not pushed at the
same time.
The ma- The guard is not
chine stops attached to the ma-
when you chine.
cut.
Heavy cutting line
is used.
The grass winds
around the motor
shaft or the trim-
mer head.
The motor is over-
loaded.
The battery pack
or machine is too
hot.
The battery pack is
disconnected from
the tool.
The battery pack is
depleted.
11
Solution
1. Remove battery pack.
2. Check contact and in-
stall the battery pack
again.
Charge the battery pack.
1. Pull the lock-out but-
ton and hold it.
2. Pull the trigger to start
the machine.
Remove the battery pack
and attach the guard to
the machine.
Use only with the nylon
cutting line of 0.065"
(1.65 mm) diameter.
1. Stop the machine.
2. Remove the battery
pack.
3. Remove the grass from
the motor shaft and trim-
mer head.
1. Remove the trimmer
head from the grass.
2. The motor will recover
to work as soon as the
load is removed.
3. When you cut, move
the trimmer head in and
out of the grass to be cut
and remove no more than
8" in pass.
1. Cool the battery pack
until its function returns
to normal.
2. Cool the machine for
approximately 10 mi-
nutes.
Install the battery pack
again.
Charge the battery pack.
EN