Power Dynamics PDY210A Manuel D'instructions page 3

UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
The label on the back/under side of the product indicates the mains voltage to which it must be connected. Check that the mains
voltage corresponds to this. Any other voltage than the one indicated may cause irreparable damage to the unit. The unit must
also be connected directly to the mains voltage and no dimmer or adjustable power supply may be used.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
CONTROLS AND CONNECTIONS
1. CHANNEL 1 OUTPUT LEVEL CONTROL: Adjust the volume of
channel 1.
2. MIC – LINE SWITCH: Switch between microphone and line channel.
3. COMBO JACK INPUT: Combo jack entry, suitable for both XLR and
6.3mm jack.
4. CHANNEL 2 OUTPUT LEVEL CONTROL: Adjust the volume of
channel 2.
5. MASTER OUTPUT LEVEL: Adjust the overall output level.
6. XLR MIX OUTPUT: XLR output for channel 1 and 2.
7. RCA LINE INPUT: RCA input for connecting audio units with line level
output (e.g. mixer, CD player).
8. POWER CONNECTOR B: Socket for plugging in the supplied power
cord.
9. FUSE HOLDER: For instructions on how to replace the fuse, please
see chapter "REPLACING THE FUSE".
10. POWER SWITCH: Switch to turn the device ON or OFF.
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
3