PowerA FUSION Manuel De L'utilisateur page 8

SETUP
RECHARGEABLE 1000 MAH INTERNAL BATTERY
Controller was charged at the factory, but if Light Bar LED is flashing red, plug
in USB cable to charge prior to initial pairing.
NOTE: Remember to charge controller at least once every 45-60 days (regardless
of use) so battery retains ability to charge. Battery capacity will gradually reduce
over time with repeated charging.
PS4™ USB WIRED MODE
1. Slide Mode Switch on back of controller to the "PS4™ USB" centre position.
2. Connect USB cable into available port on PlayStation®4 and into USB port on
controller. If PS4™ is OFF, press PS button to power PlayStation®4 "ON". The
controller's LED Connection Indicator will illuminate, and a notification should
show up on the home screen indicating the controller is plugged in.
3. For player and controller assignment, refer to the PlayStation®4 user manual.
NOTE: To remove cable, squeeze two side buttons near port and pull gently. USB
cable also includes inline release plug closer to end of cable that will disconnect
when needed.
PS4™ BLUETOOTH WIRELESS MODE
1. Upon first use, slide the Mode Switch on the back of the controller to "PS4™
BT" left position.
2. Hold both "PS" button and "SHARE" buttons together for 3 seconds until the
LED quickly flashes.
3. On the PlayStation®4 console, use a DUALSHOCK®4 wireless controller to
access Setting -> Devices -> Bluetooth Devices. To select the "PS4™ FUSION
Pro" use the official controller to Choose "YES" when prompted.
4. Press the PS button on the PS4™ FUSION Pro Controller to confirm.
PC USB WIRED MODE
1. Slide Mode Switch on back of controller to the "PC USB" right position.
2. Connect USB cable into available USB port on PC and into USB port on
controller. The controller's LED Connection Indicator will illuminate,
indicating the controller is plugged in.
3. Follow PC software or game service for controller setup or button mapping
if needed.
UNDERSTANDING LED INDICATORS
Light Bar LED performs similar to Light Bar on DualShock 4. Pro Pack Program
LED flashes during paddle programming.