Publicité
Les langues disponibles
Les langues disponibles
8. Installing cartridge holder
Place the cartridge holder(1) in the caulking
gun and turn the cartridge holder a quarter
turn. Tighten the cartridge holder firmly until
it clicks into place.
Make sure the holder is tightened firmly.
Otherwise the tool may be damaged.
Removing the cartridge holder
8.1
Push the release button (4) backwards, turn
the cartridge holder(1) a quarter turn and
remove the cartridge holder from the caulk-
ing gun.
9. Turn LED lamp on/off
CAUTION: Do not look directly at the light or
at the source of the lamp!
Press the on/off switch (5) to switch on the
LED lamp (2), press the on/off switch (5)
again to switch off the LED lamp.
10. Operation
Pull the rack rod back by the handle (6)
10.1
to the end of the cartridge holder (1).
Put the cartridge onto the cartridge
10.2
holder.
Push the rack rod (3) forward until it is
10.3
against the back of the cartridge.
Press the trigger switch (8) until the
10.4
material within the cartridge comes out
form the nozzle of the conical
applicator.
Release the trigger switch (8) to turn off
10.5
the caulking gun.
Note: When the rack rod handle reaches the
location switch, it will automatically stop.
11. Starting/Stopping the caulking
gun
To turn the caulking gun ON, depress
11.1
the switch trigger (8).
To turn the caulking gun OFF, release
11.2
the switch trigger (8).
For continuous use, press on/off switch
11.3
(8) to turn on the caulking gun, slide
lock-on knob (7) down. The lock-on
button can be unlocked by sliding the
lock-on button (7) upwards.
12. Maintenance and cleaning
WARNING: Remove the batteries before
carrying out any maintenance/ cleaning of
the tool.
Maintenance
12.1
There are no inner parts of the tool which
need maintenance.
Cleaning
12.2
• Keep safety devices, ventilation open-
ings and the motor housing as free as
possible from dirt and dust. Rub the
electric power tool with a clean cloth or
blow over it with low pressure com-
pressed air.
• We recommend that you clean your
electric power tool immediately after
each use.
• Clean the electric power tool regularly
with a damp cloth and somewhat soft
soap.
Do not use any cleaning or solvent materi-
als; these can attack the device's plastic
components. Make sure that no water can
get inside the electric power tool.
13. Storing
• Clean the device before storing it.
• Before storing check all parts for
damages.
• Store the device indoors in dry place
that is protected from dust and dirt and
extreme temperatures.
14. Technical data
Rated voltage . . . . . . . . . . . . . .6 V DC
Cartridge size . . . . . . . . . . max. 300 ml
Extrusion speed no load . max. 70 mm/min
Extrusion force. . . . . . . . . . . . . 150 kgs
Dimensions . . . . . . . . . . 38 × 6 × 22 cm
Net weight (without battery) . . . . . . 912 g
English
7
Publicité
