Jumbo Ayce BS650CA Traduction De La Notice Originale page 73

g. Switch on and off (Fig.6)
Fig. 6
3. Operation for working
a. Sanding
• The sander can be used for most sanding operations on materials such as wood,
plastic, metal and painted surfaces.
!
Don't use this machine on plaster.
WARNING
• Wear safety goggles and dust mask.
• Where possible, secure smaller work-piece to prevent them from moving under
the sander.
• Lower the sander in contact with the work-piece without pressure and then start
the sander. Move the sander slowly over the surface of the work-piece, for best
results use the sander in a linear motion not circular. Using the sander in a circular
motion may result in the belt tracking slipping. Sand with the grain, in parallel over
lapping strokes.
• To remove paint or smooth very rough wood, sand across the grain at 45º in two
directions, and then finish parallel with the grain.
• Use the front roller only to sand corners or irregular shapes.
Hold the tool firmly to control the twisting
of the tool.
To prolong the life of the tool never
overload it.
1. To start the sander, press the trigger
switch.
2. To stop the sander, release the trigger
switch.
3. If you press the lock on button while
the trigger switch is depressed, the
switch is kept in the operating position.
This is convenient when continuous
operating for extended periods of time is
required.
4. To release the lock on button, press
and release the trigger switch.
NOTE: Always lift the sander from the
work before switching on or switch off.
72 | 73 GB