Jumbo Ayce BS650CA Traduction De La Notice Originale page 71

!
Do not continue to use the sander with a sanding belt that is overworn
or damaged.
WARNING
!
Do not use the same sanding belt for wood and metal. Metal particles
become embedded in the belt and will scour a wooden surface.
WARNING
c. Adjusting sanding belt tracking (Fig.2)
!
For your safety, before plugging the tool into a power point, ensure
that the trigger switch is set to the "off" position
WARNING
Fig. 2
d. Mounting the dust extraction bag (Fig.3)
!
Always connect the dust extraction when sanding.
WARNING
1. Plug the sander into a power point
and with the sander belt tight, press
the trigger switch and then release it.
The belt rotates for a short period.
2. Whilst the belt is running, adjust the
belt tracking control knob to align the
belt to the centre of the roller.
3. Repeat the trigger action and belt
tracking adjustment until the belt is
correctly aligned.
4. Run the sander for a minute or so
to ensure correct alignment before
using the sander on a work-piece.
70 | 71 GB