Jumbo ayce R6212B Traduction De La Notice Originale page 34

Changing over from 1st gear to 2nd gear (Fig. 4)
Fig. 4
ON/OFF switch (Fig. 5)
Fig. 5
You can work at a higher or lower speed
depending on the position of the selector
switch. To avoid damaging the gear unit
you should only change over gears when
the tool has stopped.
Hold the tool firmly to control the twisting
of the tool.
To prolong the life of the tool never
overload it.
1. To start the tool, press the trigger
switch.
2. To stop the tool, release the trigger
switch.
3. If you press the lock on button while
the trigger switch is depressed, the switch
is kept in the operating position. This is
convenient when continuous operating for
extended periods of time is required.
4. To release the lock on button, press
and release the trigger switch.
3. Operation for working
a. General operation
1. Check the product, its power cord and plug as well as accessories for
damage before each use. Do not use the product if it is damaged or shows
wear.
2. Double check that the mixing paddles is securely fixed.
3. Always hold the product by both handles. Keep the handles dry to ensure
safe support. Hold the mixer firmly.
4. Ensure that the air vents are always unobstructed and clear. Clean them if
necessary with a soft brush. Blocked air vents may lead to overheating and
damage the product.
5. Switch the product off immediately if you are disturbed while working with
it and when other people enter the working area. Always let the product
come to complete stop before putting it down.
6. Do not overwork yourself. Take regular breaks to ensure you can
concentrate on the work and have full control over the product.
7. Make sure that you hold the cable behind you to avoid it becoming
entangled with the paddle.
8. The mixing paddle will continue to rotate for a while after the machine has
been switched off. If the paddle touches a surface whilst still rotating the
machine may kickback.
9. Do not start the machine until the paddle is in the mixture.
66 | 67 GB