JVC KW-NT3 Manuel D'instructions page 47

Activating/deactivating TA/PTY Standby Reception
The following functions are not available when AM is selected as the source.
TA Standby Reception
TP indicator
TP indicator TA Standby Reception
Lights up The System will temporarily switch to
Traffic Announcement (TA) if available.
• The volume changes to the preset
TA volume level if the current level is
lower than the preset level (☞ "To
adjust the TA volume" below).
Flashes Not yet activated. Tune in to another
station providing the Radio Data
System signals.
Goes off Deactivated.
To adjust the TA volume
Adjust the TA volume level between 00 to 30 or 50*
(initial: 15) by pressing [+] or [–].
* Depends on the amplifier gain control. (<Amplifier
Gain>, ☞ page 67)
PTY Standby Reception
1
2
3
PTY indicator PTY Standby Reception
Lights up The System will temporarily
switch to your favourite PTY
programme.
Flashes Not yet activated. Tune in to
another station providing the
Radio Data System signals.
Goes off To deactivate, press [Off] in step
3.
To change the PTY code for PTY Standby
Reception, repeat the above procedure.
47
Listening to the radio
PTY indicator