Publicité
Les langues disponibles
Les langues disponibles
OPERATION
Paper / Credit Card / CD Entry:
Auto Reverse Technology
When the shredder detects over-capacity shredding, the motor will immedi-
ately stop and reject paper before actual shredding begins.
Make sure you do not exceed sheet count per
pass (20 sheets max). Insert paper as straight
as possible into feed slot and release.
NOTE:
• Always turn off and unplug the shredder when not in use.
• This shredder will shred staples and small paper clips. It is recommended that you remove paper
clips whenever possible to extend the lifespan of your shredder.
• Only shred credit cards by feeding them vertically i nto the middle of the entry, releasing when shred
ding begins. Never feed more than one credit card at a time.
• Overfeeding the shredder: Shredding beyond the specified sheet capacity can result in extensive
damage to the shredder. Overfeeding will strain the machine and quickly wear and break the cutting
blades and internal components.
• Overheating with extended use: In the event that the shredder has shred continuously beyond the
maximum running time and overheating, the unit will automatically shut off. If this happens, switch
the shredder off for 50 minutes or longer before resuming normal operation.
Features a CD/DVD destroyer:
!
Caution:
center ring while feeding into the shredder. Serious injury
may occur.
Never feed more than one credit card or CD/DVD at a time.
1) Hold the CD/DVD by the edge and feed one at a time, releasing
when shredding begins.
2) Shredder will stop when the entire disc has been destroyed.
CONTINUED NEXT PAGE
6
ENGLISH
Insert one credit card at a time into
the middle of the feed slot.
Do not hold CD/DVD with finger through the
OPERATION
LED Status Indicators:
Bin full / Door open / Overload / Overheat / Power On
• Power On:
The Green LED light indicates the shredder is "On" and ready to operate when paper is inserted.
• Overheat:
The Red LED light indicates the shredder has shred continuously beyond the maximum running time
and overheating, the unit will automatically shut off. If this happens, switch the shredder Off for 50
minutes or longer before resuming normal operation.
• Overload:
The Red LED light indicates when too much paper is inserted. Use the "Reverse" mode to back up
and reduce number of sheets.
• Door Open:
The Red LED light indicates the shredder basket is not pushed in properly. Shredders with pull-out
wastebaskets feature a safety power cut off upon bin removal. Make sure the pull-out wastebasket is
properly set back into place and the green "Power On" indicator is lit.
• Bin Full:
When the "Basket is Full", the RED light will indicate it needs to be emptied. While lit, the shredder
will be inoperable until the wastebasket is cleared.
ENGLISH
7
Publicité
