Ardisam Benchmark 38249 Manuel De L'utilisateur page 20

TROUBLESHOOTING
While normal care and regular maintenance will extend the life of your equipment, prolonged or constant use may eventually require
that service be performed to allow it to continue operating properly.
The troubleshooting guide below lists the most common problems, their causes, and remedies.
See the information on the following pages for instructions on how to perform most of these minor adjustments and service repairs
yourself or by your local authorized repair center.
PROBLEM
Engine will not start.
Engine exhaust is black.
Engine runs but no material is
discharged.
Excessive branch vibration when
chipping materials.
Unusual noise or vibration when
chipping materials.
20 Get parts online at www.ardisam.com or Call 800-345-6007 M-F 8-5 CST
212cc CHIPPER SHREDDER / BROYEUSE/DÉCHIQUETEUSE 212 cm
CAUSE
1. Out of fuel.
2. Spark plug wire disconnected.
3. Engine controls not set correctly.
4. Spark plug fouled.
5. No compression. Recoil starter pulls with
no resistance.
6. No spark. Ignition problems.
7. Old or stale fuel.
1. Dirty air filter
2. Choke closed.
1. Discharge chute clogged.
2. Engine not running at full speed.
1. Chipper knives dull.
2. Tree limbs are extremely hard or dried
out.
1. Rotor overloaded with material.
2. Hammers are broken, bent, or loose.
3. Hammers frozen in place.
Owner's Manual / Manuel de l'utilisateur
REMEDY
1. Add Fuel.
2. Reconnect spark plug wire as recommend-
ed in engine manual.
3. Refer to STARTING in the engine manual.
4. Remove spark plug. Clean/replace as
recommended in engine manual.
5. See your authorized service center.
6. See your authorized service center.
7. See your authorized service center.
1. Replace air filter. See engine manual.
2. Open choke.
1. Clean out debris.
2. Set throttle control to FAST if equipped. For
fixed throttle engines see your
authorized service center.
1. Sharpen/Replace chipper knives.
2. Material is not suitable for chipping.
1. Allow unit to clear itself before adding
more material to the hopper.
2. Check assembly. Tighten or replace as
necessary.
3. Check for obstructions and debris. Repair
or replace as necessary.
3
38249 (5131-002)