Publicité
Les langues disponibles
Les langues disponibles
Do not use the vacuum cleaner without a dust bag and/or filters.
If the opening, which sucks air, hose or telescopic tube are clogged,
you should immediately turn off the vacuum cleaner Before restart-
ing the vacuum cleaner, first remove the blocking item.
Do not use the vacuum cleaner too close to heaters, radiators, cig-
arette butts, etc.
Before using the vacuum cleaner, remove sharp objects from the
floor to avoid damaging the dust bag.
Do not collect fine particles such as: flour, gypsum, printer toners,
etc., as this may clog filters and damage the vacuum cleaner.
Make sure that extension tube is fully withdrawn before you put
away your vacuum cleaner either in vertical or horizontal position.
SPECIFICATION:
Power specification:
Nominal power:
Maximum power:
Weight (without accessories)
YOUR APPLIANCE:
1. Universal 2in1 brush
2. Metal tube
3. Dust bin
4. Hose connection
5. Crevice nozzle
6. Rear wheel
7. Hose
8. Dust bin release button
9. Upholstery nozzle
10. Handle
11. On / off button
12. Power cord retract button
13. Adjust power
2
1
EN
AC 220240 V / 50/60Hz
850W
850W
4,1 kg
7
10
8
3
4
5
9
Assemble the appliance
Always unplug the appliance before attaching or removing attach-
ments!
•
Insert the end of the hose into the inlet opening. Push until
the end falls into place with an audible click.
•
Remove the hose press buttons on the hose end, unlatch
and remove the hose from the inlet port
•
Connect the telescopic tube with the hose and the brush.
•
Extend the telescopic tube to the desired length.
•
Before you start vacuuming, extend power cord cable to suffi-
cient length and insert the plug into the wall socket. The yel-
low mark on the power cord indicates it is extended almost
all the way. When you see the red mark do not pull the power
cord any further.
•
Use the on/off button to turn on the appliance. When you
have finished using the appliance, press the on/off button to
turn off the vacuum cleaner.
6
•
Unplug the cord from the wall outlet.
•
Wind up the connecting cord by pressing the power cord re-
tract button. To do this hold the cord to prevent it from tan-
gling or bumping the plug on the vacuum cleaner housing.
•
Disconnect the suction attachment — cleaning head from the
tube and disconnect the telescopic tube from the hose.
•
Close the telescopic tube.
The vacuum cleaner may be stored in a vertical position. The hose
can remain attached to the vacuum cleaner, but please be careful
not to bend it too much during storage.
Note! Figures are for illustrative purposes only. Individual models
may vary.
6
13
11
12
Publicité
