nedis WLTK1000BK Guide De Démarrage Rapide page 7

Using the product
Power button A
Menu button A
Lock button A
7
PTT button A
5
Down button A
Monitor button A
Up button A
q
Scan button A
q
Display A
3
Lamp button A
Belt clip A
r
Battery Compartment
A
t
Press and hold for 3 seconds to switch the product
8
on or off. A beep will sound.
Press 1x to select the channel.
7
Press 2x to select the CTCSS code.
Press 3x to select the VOX settings.
Press 4x to select the call tone. (CA)
Press 5x to switch the key tone on or off. (TO)
Press 6x to switch the roger beep on or off. (RO)
Press and hold for 3 seconds to lock or unlock the
product.
Press to send a call tone. The tone will be
transmitted over the set channel.
Press and hold to talk.
Press to decrease the volume.
9
Press and hold for 3 seconds to activate the monitor.
9
Press to increase the volume.
Press and hold for 2 seconds to scan for radio
channels.
Press A
light.
Press and hold to switch on the lamp.
6
Hold the latch and move the belt clip upwards, to
remove the belt clip.
Slide the belt clip in to fasten the belt clip.
If the battery is low, the battery icon will flash and a
beep will sound to indicate that the batteries must
be recharged.
Remove the belt clip A
opening the battery compartment A
Remove the batteries, if you do not use the product
for an extended period of time.
A A or A
5 7 9
r
7
q to switch on the display
from the product before
.
t