Publicité
5.3 START UP
fi«
CAUTION
• Complete any operations required to start up the machine that incorporates the pump as
recommended by its manufacturer.
• Read the instructions and warnings on the label of chemicals to be distributed by the
pump to take the appropriate steps in order to avoid danger for the operator or for the
environment.
• Store all chemicals in a safe place out of children's reach.
• Should any chemicals come into contact with your eyes, wash immediately with water. Contact
a doctor without delay and remember to take the container of chemicals with you.
• If any chemicals are swallowed, do not provoke vomiting. Contact a doctor without delay and
remember to take the container of chemicals with you.
• Operating pressure must never exceed the maximum toleration level of the pump (refer to the
"FEATURES AND TECHNICAL SPECIFICATIONS"
For the following points, please also refer to the documentation which is provided with the
control unit.
a) Set the delivery pressure to zero on the control unit so that it enters its "bypass" status.
b) Start up the pump so that it can prime.
c) Set the control unit to its "pressure" position.
d) Turn the pressure adjustment knob on the control unit until the required amount of pressure is
reached.
WARNING
• To allow the pump to prime quickly, follow the instructions at point (a) every time the pump is
drained of liquid.
• We recommend checking the level of the oil during the initial hours of its operation and to top
up the liquid if necessary as instructed in the '
6. SWITCHING OFF AND STORAGE
6.1 SWITCHING OFF
fi«
CAUTION
• Complete any operations required to switch off the machine that incorporates the pump as
recommended by its manufacturer.
No part of the pump must be in motion and no pipe must contain liquid under pressure.
a) Set the delivery pressure to zero as described in the "START UP" section.
b) Switch the pump off.
section).
PRELIMINARY PROCEDURES' section.
30
102/106
Publicité
