Xylem Jabsco 60010-2 Serie Manuel D'installation page 3

TROUBLESHOOTING
All lights are thoroughly inspected before shipping and are warranted to operate within specifications. If light does not operate.
PROBLEM
Control lever works in reverse in all directions.
Light moves in only three of the possible four directions.
Dim light (low voltage)
Bulb operates - no light movement
or
Light moves - bulb does not operate.
PARTS LIST
Key Description
1 Upper Housing
2 Lower Housing
3 Base with Gasket
4 Lens with Gasket
5 Bulb (2 Req'd)
6 Bulb Housing
7 Cable Assembly
8 Motor Kit Vertical (Upper)
9 Motor Kit Horizontal (Lower)
10 Drive Arm/Gear
11 Bulb Clip Kit
12 Screws
DUAL STATION KIT
Model
60010-0012 12V
60010-0024 24V
*NOTE: A 25' wiring cable is provided with each light.
Additional lengths may be ordered. Duel station kits require addition-
al cables (see wiring diagram). Order cable length required from table
below.
ACCESSORY CABLE LISTING
Part Number
43990-0013
43990-0014
43990-0015
43990-0016
67294-0000
NOTE: Secure cable with nylon clips or equivalent.
Protect installation at points of stress, and leave adequate slack where
cable must be flexible.
Part Number
60016-1000
60017-1000
60088-1000
60015-1000
18753-0336
60018-1000
60063-1000
18753-0458
18753-0350
18753-0457
18753-0459
18753-0471
Kit
43670-0004
18753-0335
Description
10' Cable Assembly
15' Cable Assembly
25' Cable Assembly
35' Cable Assembly
50' Bulk Cable
SOLUTION
See wiring instructions.
A. Check connectors.
B. Replace control.
C. If problem persists, return light & control for service.
A. Check voltage at power source.
B. Refer to cable listing for proper wire gage and length.
A. Check fuses on front of control.
B. Check bulb.
BULB REPLACEMENT REFERENCE
Model
60010-0012
60010-0024
BULB REPLACEMENT
1. Disconnect wires, noting location on bulb.
2. Loosen the screws on the bulb retaining clips.
3. Remove bulb from bulb housing.
4. Install new bulb making certain that the boss on the bulb
edge is in the H shaped locating clip in the center of the
bulb housing.
5. Tighten screws on the bulb clips.
6. Reconnect wires in previous positions.
12 VOLT SPOT/SPOT
RED
BLACK
3
Bulb
12V 18753-0336
24V 18753-0336
24 VOLT SPOT/SPOT
BLACK