Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The spark guard protects your
eyes and hands from sparks
flying from the workpiece.
Therefore, always use the spark
guard.
Mounting and adjusting the workpiece
support for the grinding wheel
You must regularly adjust the workpiece support in
order to compensate the wear of the grinding wheel.
n
Hold the workpiece support (21) against the side
of the wheel guard (9) and fit it using the bolts (22).
n
Tighten the fasteners handtight.
n
Adjust the distance between the
workpiece support (21) and the grinding wheel (3) to
the smallest possible value,
with a maximum of 2 mm.
n
Tighten the fasteners.
Mounting and adjusting the workpiece
support for the grinding belt
The workpiece support can be mounted at two
different positions to the respective mounting
eyes (23).
n
Hold the workpiece support (24) against one of
the mounting eyes (23) and fit it using the bolt (25)
and the screw (26).
n
Tighten the fasteners handtight.
n
Adjust the distance between the workpiece
support (24) and the grinding belt (6) to the smallest
possible value, with a maximum of 2 mm.
n
Tighten the fasteners.
Instructions for use
n
Before switching on the machine, check if all
screws and nuts are tight and if the grinding belt can
rotate freely.
Always grind on the front part of the grinding wheel
or grinding belt.
Never overcharge the machine, causing the grinding
wheel or grinding belt to come to a halt.
n
Use the grinding wheel for grinding metal
tools. Regularly cool the tools to be cut with water.
n
Use the grinding belt for grinding wooden tools.
n
The machine is not intended for permanent use.
Make sure that the machine is not overheated.
After using the machine for 30 minutes, let it cool
down to ambient temperature.
Switching on and off
n
To switch the machine on, set the on/off
switch (1) to 'I'.
n
To switch the machine off, set the on/off
switch (1) to '0'.
CLEANING AND MAINTENANCE
The machine does not require any special
maintenance.
n
Regularly remove grindings from the housing and
the covers.
TECHNICAL DATA
Mains voltage V
Mains frequency Hz
Power input W
Speed min-1
Max. thickness grinding wheel mm 20
Diameter grinding wheel mm
Wheel bore mm
Width grinding belt mm
Length grinding belt mm
Weight kg
Level of sound pressure measured
according to EN 50144:
LpA (sound pressure) dB(A)
GUARANTEE
Refer to the enclosed guarantee conditions
for the terms and conditions of guarantee.
ENVIRONMENT
Should your machine need
replacement after extended
use, do not put it in the
domestic waste but dispose of
it in an environmentally safe
way.
Made in China
230
50
250
2,950
150
12.7
50
686
8.1
< 75
2010
Publicité
Table des Matières
